Operating Instructions - Kobalt SGY-AIR176NB Use And Care Manual

ASSEMBLY INSTRUCTIONS
4. Attach the Cup Lid (G). Connect the air
hose coupling to the female plug and turn
on the compressor (See Figure 5).
NOTE Make sure the tether plug is pushed
into the vent hole on top of the cup lid
before operating the spray gun.
5. Fully open the Air Adjustment Knob (E).
While pulling the gun trigger on the paint
sprayer, adjust the air compressor
pressure up or down until the Air Pressure
Regulator (H) on the paint sprayer is
within the green range (See Figure 6).

OPERATING INSTRUCTIONS

The paint sprayer will not properly spray unless the fan direction is either set
vertically or horizontal.
• Before using desired paint in the spray gun, spray a compatible thinner or
solvent through the gun to remove any containments and residue.
• Before adding paint, make sure all thinner or solvents are removed from the
spray canister.
• It is recommended that you pour the material through a filter into a smaller
container prior to filling the paint cup.
• Set up a piece of cardboard or other scrap material to use as a target to test
spray. Continue to test spray until the desired spray pattern is achieved.
1. Adjust the direction of the fan by loosening
the air cap ring (A) by hand and turning it
to either the horizontal or vertical direction.
Tighten the air cap ring by hand.
5
6
WARNING
NOTE
1
12
G
Load paint
F
E
H
Air Cap
Horizontal Fan
Vertical Fan
Air Cap Ring
Lid