Operating Instructions - Kobalt KSP 1024B-03 Manual

OPERATING INSTRUCTIONS

4. Filling the Tank
Liquids to be sprayed must be as thin as water.
Thicker liquids will not spray properly. Do not overfill
the tank.
a. Remove the battery pack.
b. Unscrew the measuring cap (D) and remove it
from the tank (E).
c. Fill the tank with the desired amount of water
d. Measure the recommended amount of liquid.
The cap may be used for measuring up to 4 oz.
e. Carefully pour the liquid into the tank.
f. Rinse the measuring cap with clean water.
g. Screw the measuring cap back onto the
sprayer, making sure that it is tightened
securely.
Spray solutions may be premixed and poured into the sprayer, using a funnel if needed.
NOTE: Do not use this sprayer with wood sealants or wood stains.
NOTICE: If using a measuring container other than the cap, or if using a funnel to fill the tank,
be sure to thoroughly clean and rinse these items after use. If premixing the spray solution,
rinse the container used for mixing.
NOTICE: It is important to thoroughly clean the unit
after each use. Allowing liquid to remain in an idle
tool for an extended period may cause its moving
pieces and connectors to seize up.
5. To Start/Stop the Sprayer
a. To turn the sprayer ON, press the ON/OFF
switch (B).
b. To start the flow of liquid at the spray wand,
depress the trigger on the handle (I).
c. To stop the flow of liquid at the spray wand,
release the trigger.
d. To turn the sprayer OFF, press the ON/OFF
button again.
Lock-On Trigger
The lock-on trigger is convenient when spraying
for an extended period of time or when covering a
large area.
a. To lock-on, depress the trigger and slide it
forward.
b. To release the lock-on, depress the trigger and
slide it backward.
NOTICE: Make sure that the trigger is not locked
on before inserting the battery pack into the
sprayer.
4
D
5a
B
5b
11
I