Operating Instructions - Kobalt SGY-AIR70NB Manual

ASSEMBLY INSTRUCTIONS
5. Set the air compressor between 40 and 50 PSI.
Attach air line coming from compressor to the
spray gun.
NOTE: If you use the air pressure regulator adjust
the air pressure so the gauge on the regulator reads
between 40 and 50 PSI when the trigger is pulled.
6. Remove air line and canister (J) by turning it
clockwise. Fill the canister (J) about 3/4 of the
way and screw it back on the spray gun (A)
turning it counterclockwise.
NOTE: All accessories shown may not be included.

OPERATING INSTRUCTIONS

The paint sprayer will not properly spray unless the fan direction is either set vertically or
horizontal.
Before using desired paint in the spray gun, spray a compatible thinner or solvent through the
gun to remove any containments and residue.
Before adding paint, make sure all thinner or solvents are removed from the spray canister.
It is recommended that you pour the material through a filter into a smaller container prior to
filling the paint cup.
Set up a piece of cardboard or other scrap material to use as a target to test spray. Continue
to test spray until the desired spray pattern is achieved.
5
6
J
Clockwise
WARNING
NOTE
11
A
Counterclockwise
Pour paint