Mounting On The Sensor Mounting Arm - DAVIS UV Sensor Install Manual

Mounting on the Sensor Mounting Arm

Follow the instructions below to mount the sensor on the Sensor Mounting
Arm (SMA).
1. Route the sensor cable through the large hole in the mounting arm if desired.
2. Place the shield onto the body as shown below.
3. Place a flat washer over the end of each screw and insert it into the body.
4. Place a spring over the end of each screw and hold the springs in place using a #6
screw retainer.
5. Secure the sensor to the mounting arm by driving the screws into the appropriate
holes as shown below.
Page 6
P S
LACING HIELD ONTO
M UV S
OUNTING THE ENSOR ON THE
B
ODY
SMA
UV Sensor