Table of Contents
Advertisement
Trouble shooting
en
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 27
Fault
Possible
cause
The appliance is
Defective cir-
not working.
cuit breaker.
Power failure Check whether the kitchen light
The time is flash-
Power failure. Reset the time.
ing on the display.
The timer or time
The child-
cannot be set.
proof lock is
activated.
The gas burner
Power cut or
does not ignite.
damp ignition
plugs.
The gas grill does
The protect-
not work.
ing plate is
incorrectly
inserted.
--------
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Error messages on the display
If an error message with "
e.g.
-
, touch the
"ܠ
„ƒ
error message. Reset the time, if necessary.
If the fault was a one-off, you can continue to use your
appliance as normal. If the error message appears
again, call our after-sales service and quote the exact
26
Notes/remedy
Check the circuit breaker in the
fuse box.
or other kitchen appliances are
working.
Press the button with the key sym-
bol for approx. four seconds and
keep it held in until
†'""
out and the childproof lock has
been deactivated. The childproof
lock on your appliance is not
working.
Light the gas burner with a gas
lighter or a match.
Make sure that the protecting
plate is correctly inserted.
Remove the protecting plate and
reinsert it.
" appears on the display,
"
button. This will reset the
v
error message and the E no. of your appliance.
~ "Customer service" on page 27
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced.
Heat-resistant, 25 watt spare bulbs can be obtained
from our after-sales service or a specialist retailer. Only
use these bulbs.
:
Warning – Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the cold oven to prevent
1.
damage.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
goes
Remove the tea towel and switch on the circuit
5.
breaker.
Glass cover
You must replace a damaged glass cover. Suitable
glass covers may be obtained from the after-sales
service. Please specify the E number and FD number of
your appliance.
Advertisement
Table of Contents
