Table of Contents
Advertisement
Time-setting options
en
Setting the gas grill
Open the top cover. The top cover must remain
1.
open for as long as the cooker is in operation.
Turn on the main gas supply to the appliance. Insert
2.
the plug into the socket.
Insert the protecting plate into the groove below the
3.
control panel.
Insert the protecting plate with the longer edge at the
front and the curvature at the bottom.
Secure the protecting plate in the groove below the
control panel using the retainers.
Ensure that the protecting plate is engaged in the
retainers. If the protecting plate cannot be removed,
it is properly engaged. You can now safely use the
protecting plate. If it can be removed, insert it into
the groove at a slightly higher angle and make sure
that it engages in the retainers.
Close the oven door so that it is as close as possible
4.
to the protecting place.
Push in the function selector and turn it clockwise to
5.
the ignition position
Keep the function selector pressed in and turn it to
6.
the grill setting
(
.
Keep the function selector pushed in for 10 seconds
so that the safety pilot starts up. The gas coming
from the gas grill is ignited.
Check whether the flame continues to light up. If the
7.
flame goes out, repeat the process from step 5.
Once the food is cooked, switch off the function
8.
selector. Once the oven has cooled down, remove
the protecting plate.
:
Warning – Caution!
The hotplate control should not be actuated for longer
than 15 seconds. If the burner does not ignite within 15
seconds, wait at least 1 minute before repeating the
procedure.
Caution!
The gas grill only works when the protecting plate is
inserted.
Make sure that the protecting plate is correctly inserted.
20
8
.
OTime-setting options
T i m e - s e t t i n g o p t i o n s
Time-setting option Use
Timer
The timer functions like an egg timer. It runs
Q
independently of the appliance when it is
heating and does not affect the appliance.
Clock time
When the timer is not running in the fore-
v
ground, the appliance will show you the time
of day on the display.
An audible signal sounds once the timer duration has
elapsed.
Setting the timer
You can use the timer regardless of whether the
appliance itself is in use.
The maximum time that can be set is 23 hours 59
minutes. Up to 10 minutes, the timer duration can be
set in 30-second increments. The higher the value, the
larger the increments.
The timer duration starts at a different default value,
depending on which button you touch first:
5 minutes if you touch the
you touch the
button.
@
Touch and hold the
1.
symbol
is selected.
vQ
Use the
A
or
@
button to set the timer duration.
2.
After a few seconds, the timer duration will start to
count down.
The timer duration has elapsed
An audible signal will sound. The timer duration will be
zero on the display.
Touch any button to switch off the timer.
Changing and cancelling
You can use the
or
A
@
duration at any time. After a few seconds, the change
will be applied.
To cancel, use the
A
button to reset the timer duration
all the way to zero. The timer is now switched off.
Setting the time
When the appliance is connected to the power supply
or following a power failure, the time flashes in the
display. Set the time.
Press the
button.
v
1.
The time stops flashing.
Use the
or
button to set the time.
A
@
2.
The appliance applies the settings after a few seconds.
Changing the time
You can change the time again when you need to, e.g.
from summer to winter time.
button and 10 minutes if
A
button until the timer
v
button to change the timer
Advertisement
Table of Contents
