Table of Contents
Advertisement
Trouble shooting
en
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 30
Fault
Possible
cause
The appliance
The fuse is
does not start.
faulty.
Power failure Check whether the kitchen light
Disruption of
gas supply
The time is flash-
Power failure. Reset the time.
ing on the display.
The settings on
The child-
the appliance
proof lock is
cannot be config-
activated.
ured. A key sym-
bol has lit up on
the display or
†'""
.
Fan position not
The grill
working.
selector is
switched on.
The fan posi-
tion is not
selected.
Fan fault
The oven light has
The oven light
failed
is faulty
The gas burner
Power cut or
does not ignite.
damp ignition
plugs
The flame (oven)
Normal build-
does not burn
up of dirt
through all outlet
openings.
All dishes pre-
The thermo-
pared in the oven
stat is faulty.
burn within a
short period of
time.
28
Remedy/notes
Check the fuse in the fuse box.
or other kitchen appliances are
working.
Make sure that the gas supply
valves are open.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
Make sure that the grill selector is
switched off.
Make sure that the fan position is
switched on.
Call the after-sales service.
Replace the oven light. (see sec-
tion entitled "Replacing the oven
light")
Light the gas burner with a gas
lighter or a match.
Do not operate the oven without
power.
The burner must be profession-
ally cleaned.
Call the after-sales service.
The door panel
This is a nor-
steams up when
mal occur-
the oven heats
rence caused
up.
due to the
temperature
difference
The oven
The gas pres-
switches off.
sure is too
high or too
low
Power failure Check the oven's power supply.
Incorrect
installation
The cooling fan is
The cooling
not working.
fan is faulty.
--------
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault messages on the display
If an error message (starting with "
display, e.g.
–
, tap the
"ܠ
„ƒ
the error message. If necessary, reset the time.
If the error message does not go out after pressing the
button, switch off the appropriate fuse in the fuse
v
box and then switch it back on after 10 seconds.
If the error was a one-off, you can continue to use the
appliance as normal. If the error message appears
again, notify our after-sales service and quote the exact
error message and the E no. (product number) of your
appliance.
No intervention needed; this has
no effect on performance.
Check whether the correct pres-
sure regulator is being used.
Make sure that the appliance was
installed according to installation
instructions.
Call the after-sales service.
") appears on the
"
button. This will reset
v
Advertisement
Table of Contents
