5 Assembling The Pneumatic; Chain Tensioner - Oregon 720-120 Original Instruction Manual

720-120

4 5 Assembling the pneumatic

chain tensioner

To assemble the pneumatic chain tensioner,
lay the stand on the floor with the front piece
facing up.
1 First, attach the handle to the pneumatic
chain tensioner.
2 Then insert the rod through the unit and
insert the bottom part of the rod onto the
base of the stand.
585124ab_Auto Chain Grinder_OM_720-120.indd 19
4 Installation
3 To secure the rod, start from the top. Place
the provided nut on the top of the hole and
insert the bolt from the bottom of the rod
towards the top, and then through the nut.
E
J
4 Do not completely tighten the bolt. Once the
bolt is in place, slide it into the slot located
at the top part of the stand, then tighten the
bolt.
5 Once the top portion is secured, use the
second set of nuts and bolts to fix the
bottom part of the rod to the stand. After
securing both the bottom and the top, bring
the stand back to an upright position.
19
3/1/17 3:05 PM