Advertisement
5
A-1.Hold the Tension Cable (44) below the metal bracket. Guide the lower
part of the INNER Cable of the Tension Control Knob (50)
formed metal loop on the INNER Cable of the Tension Cable.
A-2.Still holding the Tension Cable (44), pull the Tension Control Knob
INNER Cable (50) away from the Metal Bracket (you will notice some
resistance at this stage) and guide the INNER Cable through the open
slot in the Metal Bracket.
A-3/A-4. Slowly release the tension on the UPPER Cable and guide it carefully
Complete the fitting as shown and if necessary, close the open section of the
metal bracket slightly with a pair of pliers as this will help to retain the cables.
Connect the lower part of the Exercise Monitor Link Wire (41) to the Exercise Monitor
Sensor Wire (42), ensuring a tight connection.
Slide the Handlebar Upright (51) on the Main Frame (33) and secure it with
4 x M8 x 20mm Allen Bolts (45), 4 x M8 Spring Washers (26) and 4 x M8
Curved Washers (27).
Note
Do NOT tighten the Handlebar
Upright at this stage.
The Tension Control Knob (50)
must be set at position "1".
42
41
Assembly
into the hole in the top of the Metal Bracket.
into the
44
43
A-1
A-2
A-3
A-4
Page 19
Hide quick links:
Advertisement
