Technical Data - Viking AMM 436 Instructions For Use Manual

In the event of a powerful collision, the blades may
be bent out. Undo the locking nut X and fold back
the blade. Install a new genuine break bolt V.
Tighten the locking nuts X and Z.
POSITIVE DRIVE BELT
Both blades are powered inside the deck by a pos-
itive drive belt.
If one of the blades has struck a solid object (e.g. a
stone), the belt tension may be altered. This can
lead to the positive drive belt 'over-meshing'
which, in the long term, can damage the blades.
Following a powerful collision, always
check that both blades are at right-an-
gles to each other (fig. 12).
The working areas of the blades overlap each oth-
er. If the blades' position in relation to each other
has been altered, there is a considerable risk of the
blades striking each other. This can entail serious
damage to the cutting deck.
If this is the case, take the machine and cutting
deck to a service workshop for repair and inspec-
tion.

TECHNICAL DATA

AMM 436
Cutting 92 cm
width
Cutting 30-85
height mm
Net weight 43 kg
ENGLISH
AMM 442 AME 442
107 cm 107 cm
30-85 30-85
mm mm
53 kg 53 kg
EN
9