Programming Options - DEI 725T Owner's Manual

Programming Options

Programming options control what your system does during nor-
mal operation, and require few or no additional parts. However,
some may require additional installation labor. The factory set-
tings are in bold.
s
Active arming (only with the transmitter) or passive arming
(automatic arming 30 seconds after the last door is closed).
s
Arming/disarming confirmation chirps on or off.
s
Passive door locking (with passive arming) or active door
locking (only when arming with the transmitter). This feature
only works if passive arming has been selected for step one.
s
The ignition switch-controlled door locking feature on or off.
With this feature on, the doors will lock 3 seconds after the
key is turned on, and unlock when the key is turned off.
NOTE: If the door is open when the ignition is turned on, the doors will
not lock.
s
Panic mode enabled/disabled with the ignition on. (Some
states have laws against siren capability in a moving vehicle).
s
Automatic Engine Disable (AED) on or off. This feature deters
theft of the vehicle, whether or not the alarm is armed. If
AED is programmed on, the starter of the vehicle will be dis-
abled 30 seconds after the ignition is turned off. The LED will
flash slowly (one-half its normal armed rate) to indicate the
AED arming cycle. 30 seconds later, the starter of the vehicle
will be disabled. To start the car, you will need to arm the car
16
2002 Directed Electronics, Inc.
©