WattWheels SCOUT LS XT 2018 Manual page 3

LCD DISPLAY FEATURES
The image shows the various features and information displayed on the wireless remote. The display is
controlled using the 5-button remote mounted on the left side of the handlebar. For more
information on the LCD display and operation please refer to the manual included. This is also on
located on our website at www.wattwheels.co.nz/manuals
LIGHTS
The front light is activated by pressing the remote button located under the throttle. Due to the power of the front
light a seperate switch is needed.
The rear light is actiavted by pressing down the light icon on the keypad. Also it will illuminate the
display at night when pressed. The rear light will also activate when the brake levers are pressed to
.
indicate to the person behind you are stopping
BATTERY DISPLAY CAPCITY
The LCD readout on the handlebar of your Scout Bike features a battery capacity gauge (much like the
fuel gauge on an automobile). Once the battery is fully depleted, the last remaining bar will begin to
flash, communicating to the user that they should cease operation immediately.
THROTTLE
The Throttle is located on the left-hand side of the handlebars in the form of a thumb piece. Please be
careful that these throttles are set to operate the Scout from stationary so any slight press of this will
propel the Scout forward. The throttle can be used when taking off from a stationary start, as a cruise
control or just if you're in need of a break! Please be aware using the throttle will drain the battery
much quicker than normal riding. Also, the throttle is not designed to climb steep hills. To get the
maximum amount of power from the Scout on steep gradients select the highest level of PAS and use
the highest gear.