Set Fixture Parameters; Dmx Address; Info Menu - ETC HIGH END SYSTEMS SolaFrame Theatre User Manual

Set Fixture Parameters

This section provides instructions to configure and set up the SolaFrame Theatre. See
the User Interface on the previous page
Provide power to the fixture before configuring it. If you do not provide power, the fixture will
use battery power to power the user interface.

DMX Address

Navigate: Main Menu → Address
Set the DMX address for the fixture. The default value is 001.

Info Menu

Set the Time Information
Navigate: Main Menu → Info → Time Info
Parameter
Current Time
Ttl Life Hrs
Last Run Hrs
LED Hours
Timer PIN
Clr Last Run
LED Time PIN
Clear LED Time
16
for information about the navigation buttons.
Value Description
Running time of the fixture from the last time that the
XXXX (Hours) fixture was powered on, shown in hours (h). The
counter resets after the fixture is turned off.
XXXX (Hours) Total running time of the device, shown in hours (h).
Running time of the fixture from the last time that the
XXXX (Hours)
run time value was reset, shown in hours (h).
Total running time of the fixture LEDs, shown in hours
XXXX (Hours)
(h).
You must enter the Timer PIN in order to access the Clr
Timer PIN XXX
Last Run menu item. The default Timer PIN is 038.
This password-protected menu item resets the Last Run
Hrs value. You must enter the Timer PIN to access this
ON
• menu item.
OFF
•
Select ON to clear the value for the Last Run Hrs
parameter for the fixture.
You must enter the LED Time PIN in order to access
LED Time PIN XXX the Clear LED Time menu item. The default LED Time
PIN is 038.
This password-protected menu item resets the LED
Hours value. You must enter the LED Time PIN to
ON
• access this menu item.
OFF
•
Select ON to clear the value for the LED Hours
parameter.
Navigate
SolaFrame Theatre User Manual