Table of Contents
Advertisement
This is what happens when the
Trigger or Triggered Sequence:
alarm "goes off " or "trips." The triggered sequence of your
system consists of the siren sounding and parking lights flashing
for the programmed duration.
A small push button mounted at a discretionary
Valet button:
location inside the vehicle. It is used to override the starter inter-
rupt when a transmitter is lost or damaged, or to enter or exit
Valet Mode.
Lighter impacts to the vehicle will
Warning Zone Response:
generate the Warning Zone response. It consists of several
seconds of siren chirps and parking light flashes.
A zone is a separate input that the alarm can recognize as
Zone:
unique. Each input to the system is connected to a particular
zone. Often two or more inputs may share the same zone.
38
© 2005 directed electronics—all rights reser ved
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Automate AM7 and is the answer not in the manual?
Questions and answers
Car starts then immediately shuts off
The Automate AM7 may start and then immediately shut off if it is programmed for voltage sense and the voltage variation between the engine off and running is too small. This can cause the remote start unit to "think" the vehicle has not started and shut it down. Adjusting the voltage check setting to "LOW" may help in such cases.
This answer is automatically generated
battery died remote start wont work How do i reprogram the remote to start the car?
To reprogram the remote for the Automate AM7 after the battery died, follow these steps:
1. Re-sync the remote: If the remote has been pressed many times out of range or the battery was removed, it may fall out of sync. To re-sync, press the remote button several times within range of the vehicle. The alarm will automatically re-sync and respond to the transmitters normally.
2. If reprogramming is needed:
- Open a door (ensure the GREEN wire H1/8 or VIOLET wire H1/6 is connected).
- Turn the ignition to the ON position.
- Within 10 seconds, press and release the Valet/Program switch the number of times corresponding to the desired channel.
- After selecting the channel, press and hold the switch. The LED will flash, and the horn will honk (if connected) to confirm.
- Do not release the Program switch until confirmation is complete.
If the learn routine is locked, it must be unlocked using the Bitwriter® before proceeding.
This answer is automatically generated