tem with your transmitter if you inadvertently open the door
while the system is armed, while still providing instant re-
sponse (even if the door is immediately closed).
➤
Turning on the ignition key will trip the same progressive re-
sponse as opening a door.
➤
The optional starter kill prevents the vehicle's starter from
cranking.
➜
multi-level security arming
Multi-Level Security Arming allows you to select which of the
system's inputs or sensors will be active and which will be
bypassed when the system is armed. (See Table of Zones section
of this guide.) Pressing
again within five seconds of arming the system will activate the
Multi-Level Security feature. Each time
different security level is selected. The different security levels are
selected as follows:
➤
Press
➤
Press
twice followed by a long chirp. Zone 2 is now bypassed.
➤
Press
three times followed by a long chirp. Zone 4 is now bypassed.
➤
Press
times followed by a long chirp. Zones 2 and 4 are now bypassed.
➤
Press
five times followed by a long chirp. All input zones, except
the ignition, are now bypassed.
© 2005 directed electronics—all rights reser ved
(only in Standard Configuration)
once: The siren chirps once. The system is armed.
a second time within five seconds: The siren chirps
a third time within five seconds: The siren chirps
a fourth time within five seconds: The siren chirps four
a fifth time within five seconds: The siren chirps
is pressed again, a
13
Need help?
Do you have a question about the Automate AM7 and is the answer not in the manual?
Questions and answers
Car starts then immediately shuts off
The Automate AM7 may start and then immediately shut off if it is programmed for voltage sense and the voltage variation between the engine off and running is too small. This can cause the remote start unit to "think" the vehicle has not started and shut it down. Adjusting the voltage check setting to "LOW" may help in such cases.
This answer is automatically generated
battery died remote start wont work How do i reprogram the remote to start the car?
To reprogram the remote for the Automate AM7 after the battery died, follow these steps:
1. Re-sync the remote: If the remote has been pressed many times out of range or the battery was removed, it may fall out of sync. To re-sync, press the remote button several times within range of the vehicle. The alarm will automatically re-sync and respond to the transmitters normally.
2. If reprogramming is needed:
- Open a door (ensure the GREEN wire H1/8 or VIOLET wire H1/6 is connected).
- Turn the ignition to the ON position.
- Within 10 seconds, press and release the Valet/Program switch the number of times corresponding to the desired channel.
- After selecting the channel, press and hold the switch. The LED will flash, and the horn will honk (if connected) to confirm.
- Do not release the Program switch until confirmation is complete.
If the learn routine is locked, it must be unlocked using the Bitwriter® before proceeding.
This answer is automatically generated