Install Memory Modules - Synology NAS FS3400 Hardware Installation Manual

Install Memory Modules

You must install genuine Synology memory module(s) to ensure system compatibility and reliability. Please install
memory module(s) into the slots as indicated below.
The following table shows the memory configuration for best practice. You must follow the configuration below
when upgrading your memory capacity, otherwise system performance and stability may suffer.
A0
16GB
32GB
16GB
16GB 16GB
16GB 16GB
32GB
32GB 32GB
32GB 32GB
Follow the steps below to install, check, or remove a memory module on your FS3400.
To install the RAM module:
1 Shut down your FS3400. Disconnect all cables connected to your FS3400 to prevent any possible damage.
2 Remove the screw on the back of FS3400. Pull the rear top cover, and put it aside.
When you remove the rear top cover, you are exposed to sensitive internal components. Avoid touching
Note:
anything other than the memory assembly when you remove or add memory.
11 Chapter 2: Hardware Setup
A1 B0
- -
- -
- 16GB
16GB
16GB
- 32GB
32GB
32GB
B1 Total Memory
- 16GB
- 32GB
- 32GB
- 48GB
16GB 64GB
- 64GB
- 96GB
32GB 128GB