Install Memory Modules
Optional Synology memory modules are designed to expand the memory of your Synology NAS. Follow the steps
below to install, check, or remove a memory module on your Synology NAS.
The following table shows the memory configuration for best practice:
A0
A1
8 GB
8 GB
8 GB
8 GB
8 GB
8 GB
16 GB
16 GB
16 GB
16 GB
16 GB
16 GB
Note:
It is required to use identical memory modules of the same capacity and frequency.
To install the RAM module
1 Shut down your RS3621xs+. Disconnect all cables connected to your RS3621xs+ to prevent any possible
damage.
2 Remove the screw on the back of you RS3621xs+. Slide open the rear top cover, then lift it up and put it aside.
Note:
When you remove the rear top cover, sensitive internal components are exposed. Avoid touching
anything other than the memory assembly when removing or adding memory.
3 The memory slots are labeled as below.
14 Chapter 2: Hardware Setup
B0
-
-
-
8 GB
8 GB
8 GB
-
-
-
16 GB
16 GB
16 GB
B1
Total Memory
-
8 GB
-
16 GB
-
24 GB
8 GB
32 GB
-
16 GB
-
32 GB
-
48 GB
16 GB
64 GB