Install Memory Modules - Synology NAS SA3200D Hardware Installation Manual

Install Memory Modules

You must install genuine Synology memory module(s) to ensure system compatibility and reliability. Be sure to
follow the configurations below for the suggested installation sequence of different memory capacities, otherwise
the system may not boot successfully, or system performance and stability may suffer.
A0
8 GB
16 GB
8 GB
8 GB 8 GB
8 GB 8 GB
16 GB
8 GB 8 GB
16 GB 16 GB
16 GB 16 GB
Follow the steps below to install, check, or remove a memory module on your SA3200D.
To install the RAM module:
1 Shut down your SA3200D. Disconnect all cables connected to your SA3200D to prevent any possible damage.
2 As shown below, loosen the screws that secure the controller on the back of SA3200D by turning it
counterclockwise. Pull the release lever to pull out one controller.
12 Chapter 2: Hardware Setup
A1 B0
- -
- -
- 8 GB
8 GB
8 GB
- 16 GB
16 GB
16 GB
16 GB
B1 Total Memory
- 8 GB
- 16 GB
- 16 GB
- 24 GB
8 GB 32 GB
- 32 GB
16 GB 48 GB
- 48 GB
16 GB 64 GB