Synology Fs3400 At A Glance - Synology NAS FS3400 Hardware Installation Manual

Synology FS3400 at a Glance

8 9
No. Article Name
1 Power Button and Indicator
2 Status Indicator
3 Alert Indicator
4 Beep Off Button
5 Drive Status Indicator
6 Drive Tray
7 Rail Kit Release Tab
8 Power Port
PSU Indicator and Beep Off
9
Button
10 PSU Fan
11
Console Port
12
PCI Express Expansion Slot
13 SAS OUT Port
14 1GbE LAN Port
15 10GBase-T LAN Port
16 USB 3.0 Port
17 RESET Button
1
For more information about the rail kit installation, please refer to the Quick Installation Guide that comes with the rail kit.
2
For more information about Synology Expansion Unit supported by your Synology NAS, please visit www.synology.com.
4 Chapter 1: Before You Start
10 11
14
Location
1. Press to power on your FS3400.
2. To power off the FS3400, press and hold until you hear a beep sound
and the Power LED starts blinking.
Displays the status of the system. For more information, see "LED
Indicator Table".
Displays warnings regarding fan or temperature. For more information,
see "LED Indicator Table".
Front
Press to deactivate the beeping sound that is emitted when a malfunction
occurs.
Displays the status of drives. For more information, see "LED Indicator
Table".
Install drives (hard disk drives or solid state drives) here.
Push in and hold to release your FS3400 from the rail kit lock.
Connect power cords here.
1. Displays the status of the power supply unit (PSU). For more
information, see "LED Indicator Table".
2. Press to deactivate the beeping sound that is emitted when a
malfunction occurs.
Disposes of excess heat and cools the PSU.
This port is reserved for manufacturing use only.
Supports one PCIe x8 add-on network interface card.
Connect Synology Expansion Unit to the SAS OUT port on the right side.
Back
Connect RJ-45 network cables here.
Connect RJ-45 network cables here.
Connect external drives, USB printers, or other USB devices to your
FS3400 here.
1. Press and hold until you hear a beep sound to restore the default IP
address, DNS server, and password for the admin account.
2. Press and hold until you hear a beep sound, then press and hold
again until you hear three beep sounds to return the FS3400 to "Not
Installed" status so that DiskStation Manager (DSM) can be reinstalled.
12
15 16
Description
13
17
1
2