Manual Configuration Of Network Connection - Wireless (Wlan) And Wired (Lan); View Settings - Hama 00054844 Operating Instructions Manual

Open network
Note
• We recommend against establishing unsecured
connections and advise you to always protect your
network against unauthorised access.
• If you plan to use an open network, you just have
to select the network ID from the list of available
networks and confirm. The radio then connects
immediately to the network.
14.2.3 Manual configuration of network connection
– wireless (WLAN) and wired (LAN)
To manually confi gure the network connection, proceed
as follows:
Press and hold
Manual configuration wireless (WLAN) –
DHCP enable
• Select the option Wireless.
• Select the option DHCP enable.
• In the input screen, enter the whole SSID (network name)
and then confirm with OK.
• Now choose the security standard used by the network.
This can be found in the confi guration options of your
router or access point.
• Depending on the encryption used, you may need
to enter the network key before the connection is
established.
[ ]
System settings

Network

Manual settings
18
Manual configuration wireless (WLAN) –
DHCP disable
The method described here assumes the DHCP server
is active (manual wireless configuration (WLAN) –
DHCP enable). However, the network information such
as IP address, subnet mask, gateway address, and DNS
(primary and secondary) must still be entered. Find this
information in the web interface of your router or access
point, or ask your network administrator. Once all the
information has been entered correctly, confirm to proceed.
The radio now attempts to establish the connection.

14.2.4 View settings

Here you can find all the most important information
about all network connections currently used or configured
on the radio, such as: MAC address, WLAN region, DHCP
active/ disabled, SSID, IP address, subnet mask, gateway
address, DNS (primary and secondary), etc.
Press and hold
[ ]
System settings

Network

View settings