Garmin EDGE 520 PLUS Owner's Manual page 36

ANT+ Sensors
Your device can be used with wireless
ANT+ sensors. For more information
about compatibility and purchasing
optional sensors, go to
http:/ /buy .garmin .com.
Putting On the Heart Rate Monitor
NOTE: If you do not have a heart rate
monitor, you can skip this task.
You should wear the heart rate monitor
directly on your skin, just below your
sternum. It should be snug enough to stay
in place during your activity.
1
Snap the heart rate monitor module
J )
onto the strap.
The Garmin · logos on the module and
the strap should be right-side up.
2
Wet the electrodes
:2)
and the contact
patches
®
on the back of the strap to
create a strong connection between
your chest and the transmitter.
6
3
Wrap the strap around your chest, and
connect the strap hook
®
to the loop
@ .
NOTE: The care tag should not fold
over.
The Garmin logos should be right-side
up.
4
Bring the device within 3m (10ft.) of
the heart rate monitor.
After you put on the heart rate monitor, it is
active and sending data.
Installing the Cadence Sensor
NOTE: If you do not have this sensor, you
can skip this task.
TIP: Garmin recommends you secure your
bike on a stand while installing the sensor.
Quick Start Manual