Type Plate - Sonnen sonnenBatterie eco 8.0/2,5 Operating Instructions Manual

3 | Product description
Degree of Protection
Rated short-withstand cur-
rent(I )
CW
Separation principle PV -> AC
Separation principle Batt. -> AC
Power meter
Voltage measurement inputs
Clamp-on current transformer
Ambient conditions
Environment
Operating temperature range
Storage temperature range
Transport temperature range
Max. rel. humidity
Permissible installation altitude
Pollution degree
Additional ambient conditions:
• The installation location must not be at risk of flooding.
• Installation room should be ventilated.
• The currently applicable building codes must be observed.
• Even floor, suitable for heavy loads.
• Observe fire control standards.
• Free from corrosive and explosive gases (ammonia content max. 20 ppm).
• Free from dust (especially flour dust or sawdust).
• Free from vibrations.
• Free access to the installation location.
• No direct sunlight.

3.2 Type plate

The type plate for the storage system is located on the outer surface of the system. The
type plate can be used to uniquely identify the storage system. The information on the type
plate is required for the safe use of the system and for service matters.
The following information is specified on the type plate:
• Item designation
• Item number
• Technical data of the storage system
1
Optimal: 5 °C ... 30 °C | Derating possible below 5 °C / above 30 °C.
10 / 36
Nominal voltage (AC): 230 V (L-N), 400 V (L-L) | max. connectible conductor
Max. measurable current: 60 A (standard), optional up to 400 A
1
IP30
10 kA
-
galvanic isolation (functional insulation)
cross-section: 1.5 mm²
Indoor (conditional)
-5 °C ... 45 °C
0 °C ... 40 °C
-15°C ... 50 °C
90 %, non-condensing
2,000 m above sea level
2
Operating instructions sonnenBatterie eco 8.0