Advertisement
10. L
T
OADING
Gently pop the printer cover's latch; then pull the cover (Figure 11). Load a roll of thermal
paper into the printer. Load it so that the print‐side of the paper will feed out facing the
operator. Close the cover by pressing on the center of the printer cover. Use the serrated bar
to tear off any excess paper.
F
C
EDERAL
OMMUNICATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at
his own expense.
P
HE
APER
C
OMMISSION
Figure 10
Figure 11
I
NTERFERENCE
S
TATEMENT
Advertisement
