Daisy - Chain - D-Link DKVM-8 User Manual

INSTALLATION
2.4 D -
AISY CHAIN
The DKVM-8 can be daisy-chained with additional DKVM-8 units through the DB-25
daisy-chain ports. The daisy-chain cable is required (not included) for proper operation.
Please refer to the example below. Here, four DKVM-8 units are cascaded together for
control over 32 computers. Recall that a maximum of 16 DKVM-8 units can be cascaded
together for control over 128 computers. Recall that the DIP-switch on the MASTER unit
must be set to BANK 0, and the SLAVE units set to a unique BANK (any from 1 through
F). See the beginning of this section for more information on the DIP-switch settings.
Cable 1
Cable 2
Cable 3
l After setting the DIP -switch on the SLAVE unit, connect the computers using the same
procedure outlined in step 5 to 9 in the previous section. DO NOT POWER UP THE
COMPUTER YET.
l Using the daisy-chain cable, connect one end to the "Master Input / Slave Output" port
of the unit. Refer to the diagram above.
n If the previous unit is the MASTER, then the other end of the cable connects to the
"Master Input / Slave Output" port of the MASTER (such as cable 1 in the diagram
above)
n If the previous unit is a slave, then the other end goes to the "Slave Input" port of
the previous slave unit (such as cable 2 and 3 in the diagram above)
l Upon connecting the daisy-chain cable to the previous unit, it should automatically
power up if the previous unit is powered up. However, it is still recommended that the
power supply be used with the slave unit. You will see the LED display on the front
panel show the units bank address setting.
Slave Input
Console PC1 PC2 P C 3
Master Input
Slave Output
Slave Input
Console PC1 PC2 P C 3
Master Input
Slave Output
Slave Input
Console PC1 PC2 P C 3
Master Input
Slave Output
Slave Input
Console PC1 PC2 P C 3
Master Input
Slave Output
~ 10 ~
1 2 3 4 5 6
SW
P C 4 P C 5 P C 6 P C 7 PC8
1 2 3 4 5 6
SW
P C 4 P C 5 P C 6 P C 7 PC8
1 2 3 4 5 6
SW
P C 4 P C 5 P C 6 P C 7 PC8
1 2 3 4 5 6
SW
P C 4 P C 5 P C 6 P C 7 PC8
ON / OFF
MASTER
AC LINE 90-240 VAC
(Bank 0)
ON / OFF
SLAVE
AC LINE 90-240 VAC
(Bank 1)
ON / OFF
SLAVE
AC LINE 90-240 VAC
(Bank 2)
ON / OFF
SLAVE
AC LINE 90-240 VAC
(Bank 3)