Enable Dhcp Server; Enable Dhcp Relay; Disable Dhcp Server/Relayer - D-Link DFL-1100 User Manual

Enable DHCP Server

To enable the DHCP Server on an interface, click on Servers in the menu bar, and then click
DHCP Server below it.
Follow these steps to enable the DHCP Server on the LAN interface.
Step 1. Choose the LAN interface from the Available interfaces list.
Step 2. Enable by checking the Use built-in DHCP Server box.
Step 3. Fill in the IP Span, the start and end IP for the range of IP addresses that the DFL-
1100 can assign.
Step 4. Enter the DNS servers that the DHCP server will assign to the clients, at least one
should be provided. If the DNS relayer is configured, the DHCP server can assign those.
Step 5. Optionally, type in the WINS servers that the DHCP server will assign to the
clients.
Step 6. Optionally type in the domain that the DHCP server assigns to the clients.
Step 7. Choose the time period during which the DHCP server will give out leases before
the client will have to renew them.
Click the Apply button below to apply the setting or click Cancel to discard changes

Enable DHCP Relay

To enable the DHCP Relay on an interface, click on Servers in the menu bar, and then
click DHCP Server below it.
Follow these steps to enable the DHCP Relayer on the LAN interface.
Step 1. Choose the LAN interface from the Available interfaces list.
Step 2. Enable by checking the Relay DHCP Requests to other DHCP server box.
Step 3. Fill in the IP address of the DHCP Server (note that it should be on another
interface then where the DHCP request is coming from), i.e., a server on the DMZ.
Click the Apply button below to apply the setting or click Cancel to discard changes

Disable DHCP Server/Relayer

To disable the DHCP Server on an interface, click on Servers in the menu bar, and then click
DHCP Server below it. Here click on the interface in which you wish to disable the DHCP
server or relayer.
Follow these steps to disable the DHCP Server or Relayer on the LAN interface.
Step 1. Choose the LAN interface from the Available interfaces list.
Step 2. Disable by checking the No DHCP processing box.
Click the Apply button below to apply the setting or click Cancel to discard changes