Electronic Control - Fagor FUR-27-N Manual Instructions

FIGURE 1
FIGURE 2
2

3.2.2 Electronic Control

ONLY FREZERS MODELS (Example: FUF_MSN/F)
After connecting your unit, turn ON rocker switch located next to the
controller. The display will light up showing the temperature inside the
unit. Also, the compressor and fan icons will flash for a period of three
minutes. After this delay the unit will start cooling.
Verify you don't have any alarms on the temperature controller. If after
you turn ON the equipment the controller shows the alarm icon or an error
code, call for technical service. They will help you fix the problem.
FIGURE 3
Temperature inside the cabinet
Compressor Icon
Evaporator Fan Icon
1
3
9
fagorindustrial.com
Thermostat it´s located inside
the unit in the right side
.
1. For best performance knob
should be pointing yellow mark.
2. Position thermostat to zero,
compressor will not work.
3. Knob to adjust thermostat
settings.
4. Knob position in "# 1", for
warmest temperature, and Knob
position in "# 7" for coldest
temperature.
To increase Set Point of Temperature
To turn the unit ON/OFF without unplugging the
equipment
To decrease Set Point of Temperature
To set a manual defrost
To Change the set point
To access programming
mode