D-Link AirPlus DWL-G730AP Manual page 40

Using the Configuration Utility in
DHCP stands for Dynamic Host
Control Protocol.
The DWL-G730AP has a built-
in DHCP server. The DHCP
Server will automatically assign
an IP address to the computers
on the LAN/private network. Be
sure to set your computers to
be DHCP clients by setting their
TCP/IP settings to "Obtain an IP
Address Automatically." When
you turn your computers on, they
will automatically load the proper
TCP/IP settings provided by the
DWL-G730AP. The DHCP server
will automatically allocate an
unused IP address from the IP
address pool to the requesting
computer. You must specify the
starting and ending address of the IP address pool.
DHCP Server-
Starting IP Address-
Ending
IP Address-
Lease Time-
Static DHCP is used to allow the DHCP server to assign some Static IP
addresses via specific MAC addresses.
Static DHCP-
Name-
IP-
MAC Address-
DHCP Client-
Home > DHCP
Select Enabled or Disabled. The default setting is Enabled.
The starting IP address for the DHCP server's IP assignment.
The ending IP address for the DHCP server's IP assignment.
The length of time for the IP lease. Enter the Lease time. The
default setting is one hour.
Select Enabled or Disabled.
Enter a name here.
Enter the last digits of the IP address here.
Enter the MAC address of the computer that will be assigned
the Static DHCP IP address.
Use this pull-down list to list DHCP clients on your network. To
copy the MAC address into the MAC address section above,
simply select the client from the pull-down list and click the
Clone button.
40 40
Router Mode (continued)