System Board - HP ProDesk 600 G4 Maintenance And Service Manual

System board

NOTE: All system board spare part kits include replacement thermal material.
NOTE: System board appearance may vary.
1. Prepare the computer for disassembly
2. Remove the access panel
3. In models with a hard drive, remove the hard drive
on page
4. Remove the fan
5. Remove the heat sink
6. When replacing the system board, make sure the following components are removed from the defective
system board and installed on the replacement system board (as applicable):
● Memory modules
● M.2 solid-state drive
Processor
●
● WLAN module
● Expansion connector board
7. To remove the system board:
a. On models with a hard drive, disconnect the speaker cable from the system board (1), and then
remove the three Torx T15 screws (2) that secure the system board to the computer.
34 Chapter 4 Removal and replacement procedures
(Access panel on page
21.
(Fan on page 30).
(Heat sink on page
(Memory modules on page
(M.2 PCIe solid state drive (SSD) on page
(Processor on page
(WLAN module on page
(Expansion connector board on page
(Preparation for disassembly on page
15).
(Hard drive on page
31).
27)
33)
23)
14).
19) and drive cage Drive cage
22)
26)