Advertisement
Assembly instructions
2. Assembly of the goal
The following tools are necessary:
- 2 wrench/ring spanners 13 mm
- 1 mallet/hammer
- 1 drill Ø 1.5 mm
- 1 thin screw driver (for net hook fixing if necessary)
for Art.-Nr. 203 4528
a) Assembly of crossbar/uprights:
Lay crossbar and uprights on the ground,
groove facing upwards and mitres joining.
Stick 4 steel plates on steel corner joint
(see 1st picture bottom left). Then stick
crossbar and upright on steel corner joint
(see other bottom pictures).
b) Assembly of steel angles:
Place steel angle on the corner of
crossbar/upright construction and screw
4 hexagon socket screws M8 x 50, DIN
931 through holes of angle and crossbar/
upright construction. Adjust goal corner
and tighten all screws.
c) Assembly of caps:
Stick caps in the open ends of uprights
(see picture bottom left). Bore them with
drill 1.5 mm through the holes provided in
the uprights.
Then fix plug pins with a hammer/mallet
(see picture bottom right).
3
Advertisement
