Heat Only Operation - Panasonic CS-MZ16VKE Service Manual

4 REMOTE CONTROL RECEIVING SOUND OFF/ON MODE
The Remote Control Receiving Sound OFF/ON Mode will be activated if the Auto OFF/ON button is pressed
continuously for more than 16 seconds (4 "beep" sounds will occur at 16th seconds to identify the Remote
Control Receiving Sound Off/On Mode is in standby condition) and press "AC Reset" button at remote
control.
Press "Auto OFF/ON button" to toggle remote control receiving sound.
a) Short "beep": Turn OFF remote control receiving sound.
b) Long "beep": Turn ON remote control receiving sound.
After Auto OFF/ON Button is pressed, the 20 seconds counter for Remote Control Receiving Sound OFF/ON
Mode is restarted.

16.2 Heat Only Operation

16.2.1 How to Activate/Deactivate Heat only Operation

Use remote controller to set heating only operation. When the unit in standby mode, follow the steps below:
a) Press continuously for more than 5 seconds to enter special setting mode.
b) Press to choose function 61, and then press
or "00" (To disable the "Heat Only" mode).
c) Press to activate "Heating only operation" or deactivate "Heating only operation".
SET
T 5secs
16.2.2 Operation mode during Heating Only Operation

The table below shows the operation mode comparison when Heating Only Operation Mode Activated and
Deactivated.
Operation
Mode
After 30s sampling, regardless of the indoor intake or
AUTO outdoor intake temperature judgment, the unit will run
Heating operation.
HEAT The unit will run Heating operation.
COOL The unit will stop and Power LED blinking.
DRY The unit will stop and Power LED blinking.
NANOE
The unit will stop and Power LED blinking.
Stand-alone
The unit will run Force Cooling Operation for
Force Cooling
X_CTRYTM [15] minutes
Force Heating The unit will run Force Heating operation.
The unit will turn ON by the timer and run Auto
AUTO Operation. After 30s sampling, regardless of the indoor
(with Timer) intake or outdoor intake temperature judgment, the unit
will run Heating operation.
HEAT The unit will turn ON by the timer and run Heating
(with Timer) Operation.
COOL The unit will not turn ON by the timer. Power LED
(with Timer) blinking.
DRY The unit will not turn ON by the timer. Power LED
(with Timer) blinking.
Cooling
The unit will stop and Power LED blinking.
Test Mode
Heating The unit will operate according to specify Heating test
Test Mode mode operation parameter.
Special setting mode
Heating Only Operation Mode Activated
or to set "01". (To enable the "Heat Only" mode)
(Function
no.)
(Options)
Heating Only Operation Mode Deactivated
After 30s sampling, the unit will judge the operation
mode base on remote controller temperature setting and
Indoor Intake Sensor (New Auto Mode) or Outdoor
Intake Sensor (Old Auto Mode).
The unit will run Heating operation.
The unit will run Cooling operation.
The unit will run Cooling Dry operation.
The unit will run Nanoe Stand-alone operation.
The unit will run Force Cooling operation.
The unit will run Force Heating operation.
The unit will turn ON by the timer and run Auto
Operation. After 30s sampling, the unit will judge the
operation mode base on remote controller temperature
setting and Indoor Intake Sensor (New Auto Mode) or
Outdoor Intake Sensor (Old Auto Mode).
The unit will turn ON by the timer and run Heating
Operation.
The unit will turn ON by the timer and run Cooling
Operation.
The unit will turn ON by the timer and run Cooling Dry
Operation.
The unit will operate according to specify Cooling test
mode operation parameter.
The unit will operate according to specify Heating test
mode operation parameter.
71
Activate or deactivate
"Heating only
operation"