Panasonic CS-MZ16VKE Service Manual page 77

5 Customization list table:
Note: The functions described in the table may not be applicable to the model and may subject to change without
further notice.
No
1 Remote control number selection
2 Solar radiation sensitivity level adjustment
[iAUTO-X/iAUTO/iCOMF, Cool & Dry] mode set temperature [Low2]
3
4 [iAUTO-X/iAUTO/iCOMF, Cool & Dry] mode set temperature [High2]
5 Heat mode set temperature Low1 selection
6 Heat mode set temperature High1 selection
7 Filter cleaning selection
Customer
Zone
8 nanoe/nanoe-G default ON selection
9 Dust sensor monitoring & LED selection
10 Auto restart selection
11 Dust sensor sensitivity level adjustment
12 ~ 49 Reserve
50 ECO demo ON
51 Light sensor check
52 nanoe-G / ECO sensor check
53 DOA check
54 Odor cut control selection
55 Frequency tolerance selection
56 Fixed fan speed selection during heat mode compressor OFF
57 nanoe check
58 Heat mode thermo shift adjustment
59 Others (Cool & Dry) mode thermo shift adjustment
60 Deice start determination judgment temperature switching
61 Cool mode disable selection
62 Heat mode disable selection
Service
63 Base pan heater selection
Zone
64 Disable fan speed reduction during cool mode thermo-Off
65 LED smart OFF selection
66 nanoe-G ON/OFF duration selection
67 Operation OFF deice function selection
68 Compressor frequency change speed selection
69 Up/Down air swing upper limit restriction selection
70 Failure diagnosis mode disable
71 Compressor Fhmax setting selection
72 ~ 99 Reserve
Customization
Name
77
Options
A, B, C, D
1, 2, 3, 4, 5
16°C ~ [High2]
[Low2] ~ 30°C
16°C ~ [High1]
[Low1] ~ 30°C
00 – Disable
01 – Enable
00 – Disable
01 – Enable
00 – Disable
01 – Enable
00 – Disable
01 – Enable
1, 2, 3
None (No display)
None (No display)
None (No display)
None (No display)
00 – Disable
01 – Enable
03 – ±3Hz
07 – ±7Hz
00 – Disable
01 – Enable
None (No display)
-3°C ~ 3°C
-3°C ~ 3°C
00 – No
01 – Yes
00 – No
01 – Yes
00 – No
01 – Yes
A – Base pan A
b – Base pan B
00 – No
01 – Yes
00 – Disable
01 – Enable
01 – Pattern 1
02 – Pattern 2
03 – Pattern 3
04 – Pattern 4
00 – Disable
01 – Enable
01 – Pattern 1
02 – Pattern 2
03 – Pattern 3
00 – Disable
01 – Enable
None (No display)
01 – Offset 1
02 – Offset 2
03 – Offset 3
Remark