Information For Installation - John Lewis JLWM1417 User Manual

8.
Remove the power supply cable and the drain
hose from the hose holders.
It is possible to see water flowing from the drain
hose. This is because the washing machine has
been tested at the factory.
9.
Remove the three transit bolts and pull out the
plastic spacers.
10.
Put the plastic caps, that you find in the user
manual bag, in the holes.
We recommend that you
keep the packaging and the
transit bolts for any transport
of the appliance.

Information for installation

1. Positioning and levelling
Washing Machine User Manual
Correctly adjusting the appliance so that it is
level prevents vibration, noise and movement of
the appliance when in operation.
1. Install the appliance on a flat hard floor. The
appliance must be levelled and stable. Make sure
that the appliance does not touch the wall or
other units and there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust the level.
All feet must rest firmly on the floor.
Warning! Do not put
cardboard, wood or
equivalent materials below
the appliance feet to adjust
the level.
2. The inlet hose
Caution! Make sure there is
no damage to hoses and there
are no leaks from the
couplings. Do not use an
extension hose if the inlet
hose is too short. Contact the
service centre for a
replacement inlet hose.
x4
9