Registering Device; Manual Configuration - Cisco 8851 User Manual

Wait some time for the phone to reboot.
NOTE: Do not unplug or remove power to the device while it is updating firmware and
configuration.

Registering Device

This section describes how to identify the Cisco phone model, requirements that must be met
and how to register the phone using manual configuration or auto provisioning.
The following topics are covered:

Manual Configuration

Auto Provisioning
Manual Configuration
This section describes how to set UAD settings, create a PBXware Extension and register the
phone.
The following topics are covered:
UAD Settings
Creating an Extension
Registering a Phone
UAD Settings
UAD settings
Log in to PBXware web administration interface
Open a new browser window and enter the IP address in order to access the PBXware's web
administration login screen. Example: http://192.168.1.10
Log in to PBXware with the e-mail address and password.
UAD settings
Navigate to Settings: UAD.
Make sure that Cisco UAD is enabled. To check the UAD status, click the Edit icon
corresponding to the Cisco phone.
Make sure Status is set to Active, Auto provisioning is set to No, and DHCP is set to Yes.
Click the Save button to save changes.