Table of Contents
Advertisement
SET UP & USE
GRILL & FAN BLADE ASSEMBLY
1. Remove the plastic nut by turning it counterclockwise. (See Fig. 7)
2. Place the rear guard so it is flush up against the head unit, making sure the handle
Fig.1
of the guard is facing upward. (See Fig. 7)
3. Screw on the plastic nut (clockwise) securing the fan guard on to the motor
housing. (See Fig. 7)
4. Install the fan blade onto the motor shaft. Make sure the fan blade slot fits into the
retaining pin of the motor shaft. (See Fig.8)
5. Attach the spinner to the motor shaft by turning it counterclockwise to secure the
fan blade. (See Fig.8)
6. Mount the front guard and join both guards together using the built-in clips.
(See Fig.9)
OPERATION INSTRUCTIONS
POWER/SPEED CONTROLS
Use controls to switch between OFF and three speed
choices 1, 2 and 3.
CLUTCH KNOB
Press down to osciallate the fan. To stop oscillation,
pull up on the clutch knob.
TILT ADJUSTMENT
To adjust the air flow upward or downward, push
the guards forward or back slightly to the desired
direction.
HEIGHT ADJUSTMENT
Loosen the height adjustment ring and adjust internal pole to the desired height. (See
Fig. 4 & 5)
Fig.2
Fig.3
Loosen
Fig.4
Fig.5
Tighten
Fig.6
Mounting H
Annular Gr
Loosen
Clip
Page 7
Advertisement
Table of Contents
