Table of Contents
Advertisement
SET UP & USE
SET UP & USE
OPERATION OF YOUR FAN
Take out the fan from the packing carton, place fan upside down (Fig 1), and rotate
the stabilizing supports 90° counterclockwise until perpendicular with the fan (Fig 2).
Turn the fan upright (Fig 3) and it is now ready for use.
Fig. 1
Rotate the support 90˚
USING YOUR FAN
• Turn speed control to choose from three speeds – 1 – Low, 2 – Medium, 3 – High
• When finished, turn speed control to 0 – Off
REPLACING THE FUSE
• Disconnect fan from power outlet by grabbing the plug at the end of the cord. Do
not unplug by pulling the cord itself
• Open fuse cover located in the side of the power cord
plug by sliding it toward the plug blades (Fig 4.)
• Remove fuse carefully by taking a small tool and slowly
prying out one end. Once you have one end out, slowly
pry out the other end.
• To avoid the risk of fire, replace only with similar 2.5
Amp, 125V fuse. Be sure to install the replacement fuse in the same direction as the
original one.
• Close fuse cover by sliding cover toward the top of the plug.
CAUTION: Do not attempt to replace the plug itself. Discard the product entirely if
the plug itself is damaged.
CLEANING AND MAINTENANCE
. Be sure to unplug from the electrical supply source before cleaning
. Plastic parts of the fan should be cleaned with mild soap and a damp cloth or
sponge. Rinse with clean water to remove any soapy film residue.
. Be sure not to get water or any other liquid inside the motor.
Fig.2
Location for the bracket
when using.
Fig.3
Fig. 4
Page 5
Advertisement
Table of Contents
