Motor Unit And Base Assembly; Fan Head Assembly - Westinghouse WSFDAN1201SV Instruction Manual

MOTOR UNIT AND BASE ASSEMBLY

Required tools: Cross-head (Phillips) screwdriver.
1. Remove the tilt adjustment knob (7), long screw, small screw
and small knob from the bottom of the motor unit (14).
2. Align the 4 screw holes on the bottom of the motor unit (14)
with the 4 screw holes on the neck (2) of the base.
3. Insert the long screw through the bottom screw holes and
tighten with the tilt adjustment knob (7) (Fig. 1, 2).
4. Tighten the small screw in the screw hole above the tilt-
adjustment knob (7) by turning clockwise with the screwdriver.
Then tighten the small knob in the remaining screw hole.
(Fig. 3).

FAN HEAD ASSEMBLY

1. Insert the back of the rear guard (12) into the motor shaft (13).
2. Align the 4 screw holes on the rear guard (12) with the 4 screw
holes on the motor unit (14) (Fig. 4), ensuring that the carry
handle (5) is at the top. Tighten the 4 screws (provided)
clockwise with the screwdriver (Fig. 5).
3. Loosen the screw on the back of the fan blades (11) and align it
with the flat indentation on the motor shaft (13) (Fig. 6). Insert
the fan blades into the motor shaft until the screw is right on
top of the flat indentation (Fig. 7). Tighten the screw clockwise
with the screwdriver.
4. Carefully rotate the fan blades (12) a few turns with your
hand to make sure that they are levelled and spin smoothly.
Reassemble if necessary.
5. Open the locking clips (6) around the rim of the front
guard (10) and hook the top onto the rear guard (12).
6. Align the screw holes on the bottom of both guards, and use
the screwdriver to tighten the screw clockwise.
7. Close the locking clips (6) to lock the guards.
HOW TO USE
EN
9