Page 1
User Manual 40” Tower Fan MODEL: WFTR40W 1. READ these instructions carefully before installing and operating the appliance. Keep them for further reference. 2. Record in the space below the “SERIAL/MODEL NUMBER” found on the back or bottom of your appliance and retain this information for future reference.
SAFETY INFORMATION DANGER WARNING CAUTION DANGER - Immediate hazards WARNING - Hazards or unsafe CAUTION - Hazards or unsafe which WILL result in severe practices which COULD result in practices which COULD result in personal injury or death severe personal injury or death minor personal injury IMPORTANT SAFETY INSTRUCTIONS WARNING...
Page 3
SAFETY INFORMATION HANDLING ALKALINE BATTERIES 1. Should fluid from the battery accidentally get into your eyes, this may cause damage to your eyes. Do not rub them. Immediately rinse your eyes with clean tap water and then consult a physician immediately. 2.
NOTE: Neither Westinghouse nor the dealer can accept any liability for damage to the product or personal injury resulting from failure to observe the electrical connection procedures.
Fig. 5 Fig. 1 SET UP & USE PARTS & FEATURES Pedestal Assembly Fig. 2 Fig. 6 Extrusions Body Pedastal Support Base Assembly Fig. 3 Front / Rear Base Fig. 7 Positioning Pole Positioning Hole Fig. 4 Pedestal / Tower Screw (1) Base Assembly Screws (3) Power Cord Fig.
SET UP & USE SET UP & USE ASSEMBLY OF PEDASTAL AND BASE PEDESTAL ASSEMBLY • Line up the left and right pedestal suports and firmly snap together Fig. 1 (Fig. 1). BASE ASSEMBLY • Align the two portions of the circular base and snap together by gently pushing the 4 extrusions (Fig.
Pedestal Assembly Fig. 2 Extrusions SET UP & USE Base Assembly REMOTE CONTROL BATTERY INSTALLATION Fig. 3 1. Press down on the battery compartment cover and slide Remote Control it out. Positioning Pole Positioning Hole 2. Insert 2 “AAA” batteries (not included) making sure that Battery Battery Cover the positive terminals are facing the proper way.
SET UP & USE SET UP & USE CLEANING AND MAINTENANCE • Before cleaning and assembling, unplug the fan. • To ensure adequate air circulation to the motor, keep vents at the rear of the motor housing free of dust, debris, etc. Unplug fan before using a vacuum cleaner to clean these vents.
TROUBLESHOOTING & WARRANTY BEFORE YOU CALL FOR SERVICE IF THE APPLIANCE FAILS TO OPERATE: A) Check to make sure that the appliance is plugged in securely. If it is not, remove the plug from the outlet, wait 10 seconds and plug it in again securely. B) Check for a blown circuit fuse or a tripped main circuit breaker.
TROUBLESHOOTING & WARRANTY LIMITED WARRANTY 12. Transportation and shipping costs associated with the replacement of Westinghouse brand is used under license. the unit. 13. Service calls to repair or replace the Any repair, replacement, or warranty service, house fuse, reset the circuit breaker or and all questions about this appliance should correct the wiring in the house.
Page 12
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse Electric Corporation. Used under license by W Appliance Company. All Rights Reserved. 030117 Page 12...