Zanussi ZZB25601XX User Manual page 15

Pull the front of the
1
shelf support away
from the side wall.
Install the shelf supports in the opposite
sequence.
Cleaning the oven door
The oven door has two glass panels. You can
remove the oven door and the internal glass
panel to clean it.
The oven door can close if you try to
remove the internal glass panel
before you remove the oven door.
CAUTION!
Do not use the appliance without the
internal glass panel.
Open the door fully
1
and hold the two
door hinges.
www.zanussi.com
1
2
Pull the rear end of
2
the shelf support
away from the side
wall and remove it.
Lift and turn the
2
levers on the two
hinges.
Close the oven door
3
halfway to the first
opening position.
Then pull forward and
remove the door from
its seat.
Release the locking
5
system to remove the
internal glass panel.
2
1
First lift carefully and
7
then remove the
glass panel.
Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, install the
glass panel and the oven door. Do the above
steps in the opposite sequence.
The screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel frame
on the screen-printing zones is not rough when
you touch it.
Make sure that you install the internal glass
panel in the seats correctly.
Put the door on a soft
4
cloth on a stable
surface.
90°
Turn the two
6
fasteners by 90° and
remove them from
their seats.
15