Installation Guide - CyberPower CyberSwitch CSW8RU User Manual

Cyberswitch network management system
Table of Contents

Advertisement

INSTALLATION GUIDE

Step 1. Hardware Installation
1. Connect the Ethernet cable to the LAN port of the CyberSwitch.
2. After the above procedures are completed, please turn on the CyberSwitch. To reset the IP
Address to default value, press the Reset Button on the CyberSwitch front panel
continuously for 6 seconds that the Status Indicator will blink for 3 times continuously and
then you will hear a short beep in the end.
3. Power off the CyberSwitch and then power back on.
Step 2. Setup the IP address for the CyberPower CyberSwitch.
THREE OPTIONS:
Option 1: Setup the IP address via DOS
1. If you have a DHCP server, the DHCP server will give you the MAC address to IP mappings.
Just open your Web Browser with the IP provided by DHCP server.
2. If you don't have DHCP server, obtain the MAC address for the CyberSiwtch. (Each
CyberSwitch has a unique MAC address which can be found using option 3: on page 5 of
this manual.).
3. For example: to assign an IP address 192.168.20.240 which is in the same subnet as your
computer with CyberSwitch, which has the MAC address for example 00-0c-15-00-01-23:
Open a DOS prompt and run an ARP command:
and press Enter to set the IP address.
4. To verify the setting, run a ping command:
If you receive a reply, the IP address has been set.
To find an IP address for the CyberSwitch, please refer to Appendix 2.
If you want to assign an IP address which is in a different subnet to your computer, you should
follow Step 2. Then you can enter the Browser Mode Configuration and enter the correct IP
address and subnet for its final location.
1. Open your Web Browser (Internet Explorer or Netscape)
2. Enter the IP Address which you assigned in Step 2, Option 1 above.
3. On the login page, enter the current password. The default username is "cyber" and the
default password is "cyber".
4. Select Network and click on TCP/IP configuration to change the IP address. Click Apply to
save the changes.
Example: arp –s 192.168.20.240 00-0c-15-00-01-23
ping 192.168.20.240
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cyberswitch csw8re

Table of Contents