Table of Contents
Advertisement
[Network] menu contains [TCP/IP], [Access Control] and [Trap Notification].
[TCP/IP] displays IP Address, Subnet Mask, Default Gateway, and Web/Http Port as well as
enable or disable the BOOTP/DHCP configuration.
Click [Apply] to activate the settings, click [Cancel] to revert to previous inputs.
[Access Control] serves to control access to the NMS. Limit system data access through
SNMP.
1. Input the manager IP address. This address will limit the access to the NMS. The default
value 0.0.0.0 or 255.255.255.255 allows access for all NMS.
2. Input the community (functioned as password, maximum of 15 characters).
3. Select one of the permission options: [Read], [Write], or [Disable].
4. Click [Apply] to activate the settings, click [Cancel] to revert to previous inputs.
Definitions for Permission levels:
Read
The NMS can read data at any time, but can never write data.
Write
The NMS can read and write data at any time (provided there is not
another user logged in).
Disabled
The NMS cannot use 'Read' or 'Write'.
[Trap Notification]: Identify NMS that will receive traps.
1. Click on "Trap Receiver" to enter the [Trap Configuration] page
2. Input the receiver's name and IP address. This address will identify the receiver of traps.
The default value 0.0.0.0 or 255.255.255.255 defines all NMS as receivers.
3. Input the community (functioned as password, maximum of 15 characters).
4. Click [Apply] to activate the settings, click [Cancel] to revert to the previous settings.
5. The applied Trap Receiver will be listed on the [Trap Notification] page. You could click a
Trap Receiver to change the name, the IP, the community and the status including [Enable],
[Disable], and [Delete].
Enable: The trap will be generated.
Disable: The trap will not be generated.
Delete: The trap receiver will not remain on the list.
11
Advertisement
Table of Contents
