Fitting The Hose Guide; Fitting The Floor-Tool - Numatic TTV 4555 Owner's Instructions Manual

Fitting the Hose Guide

The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched
off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation.

Fitting the Floor-tool

The floor-tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor-tool gets snagged, whilst in transit.
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
15
Machine Set-Up
Note:
14
Fit the floor-tool and retain using the detent pin (Fig.14).
Push waste collection pipe onto the
floor-tool; ensure a tight fit (Fig.15).
Raise the floor-tool for transit or lower for
cleaning operation using the lifting handle
fitted to the back of the machine (Fig.16).
For fitting the floor-tool blades
(See Page 20).
10
Refit vacuum hose to the Floor-tool when finished.
Note:
DO NOT push the vacuum hose onto the Floor-tool
with the Floor-tool in the raised position.
16