9. Make sure that LEDs on the switch indicate that it is operating correctly (see
"Information LEDs" on page
10.
If you have another switch to install, repeat Step 3 through Step
the next step.
11. Install any port transceiver modules or Direct‐Attach Cables (DACs) needed for the
switch. For information and instructions, see "Connecting Switch Ports" on
page
© Copyright Lenovo 2018
Note: The switch may take up to two minutes to complete the POST. During POST,
the Power LED continuously flashes. Once POST has successfully completed, the
Power LED remains on and the Error LED is off.
21 and the documentation that comes with the transceiver modules or DACs.
34).
Chapter 2: Installing and Removing the NE2552E
9; otherwise, go to
19