Connecting Switch Ports; The Serial Console Port - Lenovo ThinkSystem NE2552E Installation Manual

Flex switch
Hide thumbs Also See for ThinkSystem NE2552E:
Table of Contents

Advertisement

Connecting Switch Ports

The Serial Console Port

Connecting the Serial Console Cable
© Copyright Lenovo 2018
The switch includes a variety of external port options. Fixed ports, such as the 
RJ‐45 management port, can be connected directly by attaching the appropriate 
cable. Modular ports, such as Small Form‐factor Pluggable Plus (SFP28) and Quad 
Small Form‐factor Pluggable Plus (QSFP28) ports, require the installation of a 
transceiver module before the cable can be attached. This section covers each 
supported port type separately:
"The Serial Console Port" on page 21
"The RJ‐45 Management Port" on page 22
"SFP28 Ports" on page 24
"Installing an SFP28 Optical Transceiver" on page 26
"QSFP28 Ports" on page 27
"Installing a QSFP28 Optical Transceiver" on page 29
Notes:
The illustrations in this document might differ slightly from your hardware.
While the information in this section describes the 25 Gigabit Ethernet (GbE) 
SFP28 and 100 Gigabit Ethernet (GbE) QSFP28 transceiver modules, it also 
applies to the 10 GbE SFP+ transceiver modules 
The switch supports MSA‐compliant copper DACs, up to 5 m (16.5 ft.) in length.
This section discusses connecting and disconnecting the serial console cable.
To use the serial console, connect a serial cable to the RS‐232 serial console port of 
the switch and the other end of the cable to the console device.
Note: You must use one of the two cables in the Serial Access Cable option.
If your console device uses a standard RS‐232 DB9 connector, attach the included 
mini‐USB‐to‐DB9 serial cable. Otherwise, if your console device uses an RJ‐45 
connector, attach the included mini‐USB‐to‐RJ‐45 serial cable and a user‐supplied 
RJ‐45 adapter cable. Your adapter cable depends on the pin out required by your 
console device. Pin out of the mini‐USB‐to‐RJ‐45 cable is as follows:
Table 2.
Pin out for the included mini‐USB‐to‐RJ‐45 cable
PIN #
Function
1
Not connected
2
3
4
5
Direction
RXD
In
TXD
Out
GND
GND
Chapter 2: Installing and Removing the NE2552E
21

Advertisement

Table of Contents
loading

Table of Contents