Pc With Wi-Fi Adapter - D-Link DSL-2750U User Manual

DSL-2750U 3G/ADSL/Ethernet Router with
Wi-Fi and Built-in Switch
User Manual
Click the ОК button. Now your computer is configured to obtain an IP address automatically.

PC with Wi-Fi Adapter

1. To connect via 3G network: connect your USB modem to the USB port located on the back
panel of the router.
!
If you need to connect or change a USB modem to another one when the router is powered
on, power off the device, connect the modem to the USB port, and power on the router.
2. To connect the router to a DSL line: connect a phone cable between the DSL port of the
router and the ADSL OUT port of the splitter. Connect your phone to the PHONE port of
the splitter. Then connect another phone cable between a phone jack and the ADSL IN port
of the splitter.
3. To connect the router to an Ethernet line: connect the Ethernet cable between any of four
Ethernet ports located on the back panel of the router and the Ethernet line.
4. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
5. Turn on Wi-Fi: push the relevant button on the back panel of the router.
6. Turn on your PC and wait until your operating system is completely loaded.
7. Turn on your Wi-Fi adapter. As a rule, modern notebooks with built-in wireless NICs are
equipped with a button or switch that turns on/off the wireless adapter (refer to your PC
documents). If your PC is equipped with a pluggable wireless NIC, install the software
provided with your Wi-Fi adapter.
Figure 5. The Internet Protocol (TCP/IP) Properties window.
Page 15 of 110
Installation and Connection