TP-Link ARCHER C1200 User Manual page 12

Chapter 2
Note: If 2.4GHz LED and 5GHz LED are off, press the WPS/Wi-Fi On/Off button for about 2 seconds, and then
check the LEDs again in a few seconds.
2. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
• Method 2: Wirelessly
1 ) Find the SSID (Network Name) and Wireless Password printed on the label at
the bottom of the router.
2 ) Click the network icon of your computer or go to Wi-Fi Setting of your smart
device, and then select the SSID to join the network.
Computer
Connections are available
Wireless Network Connection
TP-LINK_XXXX
TP-LINK_XXXX_5G
Connect automatically
√
• Method 3: Use the WPS button
Wireless devices that support WPS, including Android phones, tablets, most USB
network cards, can be connected to your router through this method (WPS is not
supported by iOS devices).
Note:
The WPS function cannot be configured if the wireless function of the router is disabled. Also, the WPS function will
be disabled if your wireless encryption is WEP. Please make sure the wireless function is enabled and is configured
with the appropriate encryption before configuring the WPS.
1. Tab the WPS icon on the device's screen.
2. Immediately press the WPS button on your router.
Power 2.4GHz 5GHz Internet
On On On
Ethernet cable
< Settings
Wi-Fi
CHOOSE A NETWORK...
TP-LINK_XXXX
Connect
TP-LINK_XXXX_5G
Other...
Connect the Hardware
On
Smart Device
Wi-Fi
8