required connector. Use the instructions shipped with the option to help you make the connection and install
any software or device drivers that are required for the option.
Replacing the frame stand
To replace the frame stand, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
3. Loosen the screw that secures the frame stand. Then, lift the frame stand to remove it from the computer.
Note: The screw cannot be removed from the frame stand.
Figure 8. Removing the frame stand
4. Insert the two tabs
pivot down the frame stand.
Figure 9. Installing the frame stand
50
Lenovo S200z User Guide
1
on the new frame stand into the corresponding holes in the chassis. Then,