Running; Stopping - Echo CS-355T Operator's Manual

CS-355T

Running

The saw chain should not move at idle, otherwise serious
personal injury may result.
Note: If saw chain moves adjust carburetor according to
"Carburetor Adjustment" instructions in this manual, or see
your dealer.
1. After engine starts, allow it to
return to idle and warm up
before using.
2. Move chain brake lever (A) fully
REARWARD to UNLOCK chain
brake.
3. Squeeze throttle trigger (B)
gradually and increase engine
speed.
4. The chain starts running when
the engine reaches clutch
engagement speed.
5. Confirm proper acceleration
and lubrication of chain and
bar.
6. Do not run the engine at high speed unnecessarily.
7. Be sure that saw chain stops moving when throttle trigger is released.

Stopping

1. Release throttle trigger and
allow engine to idle.
2. Move control lever (A)
REARWARD to "STOP"
position.
X7503323507
© 01/2021 ECHO Incorporated
OPERATION
A
B
A
33