Starting Cold Engine - Echo CS-355T Operator's Manual

OPERATION

Starting Cold Engine

Make sure the bar and chain are free from any obstruction when
starting the chain saw.
1. Move chain brake lever fully
FORWARD to LOCK chain
brake before starting.
2. Fill the fuel tank with fuel
mixture. Do not over fill.
3. Fill the chain oil tank with
lubricant. Do not over fill.
4. Move control lever (A)
FORWARD to "COLD START"
position.
5. Push purge bulb (B) 3 to 4
times or until fuel is visible in
purge bulb.
6. Securely hold the chain saw as
shown. When starting the chain
saw place the unit on flat
ground and hold front handle
with left hand and firmly hold
rear end of rear handle with
right knee. Pull starter handle
with right hand several times
until first firing sound.
Note: Do not pull starter rope out to maximum position. Do not allow
recoil handle to snap back against the casing.
30
CS-355T
A
1
B
X7503323507
© 01/2021 ECHO Incorporated
2