Connectors - Axis P1365 Mk II User Manual

AXIS P1365 Mk II Network Camera
Technical specifications
For SD card recommendations, see www.axis.com

Connectors

Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NOTICE NO NO TICE TICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. All cables connecting the product to the network and that are routed outdoors
or in demanding electrical environments shall be intended for their specific use. Make sure that the network devices
are installed in accordance with the manufacturer's instructions. For information about regulatory requirements, see
Electromagnetic Compatibility (EMC) on page 2 .
Audio connector
The Axis product has the following audio connectors:
• Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.
• Audio out (green) – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an
active speaker with a built-in amplifier. A stereo connector must be used for audio out.
For audio in, the left channel is used from a stereo signal.
3.5 mm audio connectors
(stereo)
Audio Input
Audio Output
I/O connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will
show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input – For connecting devices that can toggle between an open and closed circuit, for example: PIRs, door/window
contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes active (shown
under System Options > Ports & Devices).
4–pin terminal block
Function
0 V DC (-)
1 Tip
Line out, mono (stereo connector
compatible)
Pin Notes
1
DC ground
2 Ring
Line out, mono (stereo connector
compatible)
73
3 Sleeve
Ground
Ground
Specifications
0 V DC