Crown AMB-5 User Manual page 77

IQ–MSD Turbo 1.4 Advanced IQ System Software
Action: Sets the operating mode for the Button. As its name suggests, the Push On/Push Off mode causes
the Button to behave like a normal two-state pushbutton that you press and release once to send the On command
and then press and release again to send the Off command. The Momentary mode causes the Button to send
the same command each time the Button is pressed. The Hold In To Operate mode causes the Button to
send the On command when it is pressed and the Off command when it is released.
On: Sets the color when the Button is turned on.
Off: Sets the color when the Button is turned off.
Delay (ms): Causes a delay in milliseconds between the time the Button is pressed until the its command is sent
and the Button color is updated. Enter a value of 0 (zero) to turn off the delay. The delay timer is reset every time
the Button is pressed. The Delay attribute has no affect when the Action is set to Hold In To Operate.
Note: Buttons configured to control amplifier global all commands will control amplifiers on all Crown Bus loops.
However, the same functions, when controlled from a drone, are specific to just one Crown Bus loop.
On Level: Sets the turn-on level when the Button is used to control a level function.
Off Level: Sets the turn-off level when the Button is used to control a level function.
Inverted: Swaps the on/off commands so that the Button sends the Off command when it is turned on and the
On command when it is turned off.
Relative: (Drone AUX inputs only.) Causes changes made to a level function to be made relative to its present
level. When this attribute is turned off, the on/off levels are absolute. This attribute is only available when the Button
is used to configure an AUX input on a drone.
Hidden: Causes the button not to be displayed on the graphics plate. However, the button is fully functional.
Hidden buttons can be used to create hidden hot spots. However, care should be taken using this attribute so that
hidden buttons are not "lost" on the graphics plate. If this happens, press A + h to make all hidden buttons visible.
Pressing A + h a second time will toggle the hidden buttons back to their hidden state.
Refresh: This attribute only affects Buttons that are linked to UCODE-compatible IQ components. If Refresh is
turned on and the Button has been placed inside a container object, every time the state of the Button changes, all
objects in the parent container will retrieve their state from the IQ component and redisplay themselves if neces-
sary.
Page 77